USER FORUM
(you are viewing a thread; or go back to list of threads)
Error Message: Zero length edge! (by Md Faris)
I have this sketch which is the plan view of a wooden plank with groove for overlap joint. When I first did it came with an error message: not closed contour or not all same style. And I read in this forum that the edges cannot overlap. So I split the lines where they intersect. Now the error message I get is: Zero-length edge!
If I go to home in the properties window I see g002-sketch-in plane has an error status.
But I check all the lines have length. If that window indicates which lines or constraints had the error its easier to troubleshoot. So I attach this file if you can give me any idea.
Regards
Faris
If I go to home in the properties window I see g002-sketch-in plane has an error status.
But I check all the lines have length. If that window indicates which lines or constraints had the error its easier to troubleshoot. So I attach this file if you can give me any idea.
Regards
Faris
(no subject) (by Andrew)
You have created multiple instances of coincident points, as illustrated by where I dragged lines. You can get rid of the remaining area by selecting all lines and toggling them to construction.
(no subject) (by Md Faris)
Thank you. This did the trick.
It must be that when I split the lines that intersect it created those additional points. If I did not move the lines I would not be able to see it. When the lines were split it lost its original distance constraints to those points. I had to add more distance constraints after deleting those points.
Thanks again
It must be that when I split the lines that intersect it created those additional points. If I did not move the lines I would not be able to see it. When the lines were split it lost its original distance constraints to those points. I had to add more distance constraints after deleting those points.
Thanks again
(no subject) (by Walter Cadek)
I think the error is not where you think, I tried to move the right point and
found a line which should not exist.
I found in my designs a lot of errors by changing the points an see what happens.
See the atteched corr-file for better understanding.
found a line which should not exist.
I found in my designs a lot of errors by changing the points an see what happens.
See the atteched corr-file for better understanding.
Post a reply to this comment: