USER FORUM
(you are viewing a thread; or go back to list of threads)
not closed controur, or not all the same style! (by Dietrich)
Hey all,
I just started my first sketch I might be missing something very basic.
I tried to do a "chest" that can be cut with a laser cutter from cardboard or similar. Two sides of the chest worked well the third side alway says "not closed controur, or not all the same style!". However I cannot find any position where the contour is not closed. Whats the easiest way to find such a gap?
I think it actually does not matter for the lasercutting... but it would be nice to see the model in the virtual world too instead of frames of the modle...
Thank you so much for your kind help.
I just started my first sketch I might be missing something very basic.
I tried to do a "chest" that can be cut with a laser cutter from cardboard or similar. Two sides of the chest worked well the third side alway says "not closed controur, or not all the same style!". However I cannot find any position where the contour is not closed. Whats the easiest way to find such a gap?
I think it actually does not matter for the lasercutting... but it would be nice to see the model in the virtual world too instead of frames of the modle...
Thank you so much for your kind help.
(no subject) (by Andrew)
You have created two lines overlapping existing lines at the corner where the message appears, deleting them fixes the problem, running the mouse over the list of entities in the properties window may help find similar problems, as does deleting lines where that message appears. Fixed file attached.
Thank You (by Franz Dietrich)
Thank you for the hint! It that helped me understand the program more!
Post a reply to this comment: