USER FORUM
(you are viewing a thread; or go back to list of threads)
Change image aspect ratio (by sirion)
Hello,
I would like to change the aspect ratio of an image I imported in SolveSpace (my use case is that I need to fine tune the aspect ratio of the image to achieve exactly a given width and height).
I have wondered a bit in the docs and the menus, but I could not find such option (even if inside the .slvs file I see "Request.aspectRatio=1.57337220602526728364" in the section that defines the imported image).
Is it possible to change it inside SolveSpace? (also, I tried constraining both the width and height of the image, but no luck).
P.S.: that's a really nice piece of software, it's a pity it doesn't seem to have the fame it deserves. I've found it out only after a lot of googling looking for alternatives to FreeCAD (which is not enough stable on my machine).
I would like to change the aspect ratio of an image I imported in SolveSpace (my use case is that I need to fine tune the aspect ratio of the image to achieve exactly a given width and height).
I have wondered a bit in the docs and the menus, but I could not find such option (even if inside the .slvs file I see "Request.aspectRatio=1.57337220602526728364" in the section that defines the imported image).
Is it possible to change it inside SolveSpace? (also, I tried constraining both the width and height of the image, but no luck).
P.S.: that's a really nice piece of software, it's a pity it doesn't seem to have the fame it deserves. I've found it out only after a lot of googling looking for alternatives to FreeCAD (which is not enough stable on my machine).
Post a reply to this comment: