USER FORUM
(you are viewing a thread; or go back to list of threads)
Intersection after tangent arc at corner leads to incorrect behavior (by Vikenti)
If i do 1) tangent arc at corner then 2) intersection a side with this tangent arc with any geometry then i get extra strange lines. See example file (try to move circle and you'll see these lines).
If i first intersect, then create tangent arcs - it's all works fine as expected.
If i first intersect, then create tangent arcs - it's all works fine as expected.
(no subject) (by Jonathan Westhues)
When you round a corner with a tangent arc, you can either (a) delete the old lines and replace them with the new shorter lines, or (b) keep the old lines as construction lines, and create the new shorter lines too.
By default, SolveSpace chooses (b), since rounding the corner might otherwise lose constraints. To choose (a), click Sketch -> Tangent Arc at Point and check the "delete original entities afterward" box in the browser.
By default, SolveSpace chooses (b), since rounding the corner might otherwise lose constraints. To choose (a), click Sketch -> Tangent Arc at Point and check the "delete original entities afterward" box in the browser.
(no subject) (by Vikenti)
I can't find option "delete original entities afterward" anywhere neither in solvespace 2.2 nor in solvespace 2.3. Where is it?
For example:
1. I draw rectangle
2. select point
3. do "Tangent arc at point" or shift+a
4. it creates fillet and property browser shows me only selection information.
For example:
1. I draw rectangle
2. select point
3. do "Tangent arc at point" or shift+a
4. it creates fillet and property browser shows me only selection information.
(no subject) (by Jonathan Westhues)
Sketch -> Tangent Arc without any points selected.
(no subject) (by Vikenti)
Thanks a lot!!!
Post a reply to this comment: