USER FORUM
(you are viewing a thread; or go back to list of threads)
Create grooves in recessed surface (by Gian)
Hello,
I am want to create a grooved recessed surface.
So I draw a sawtooth polygon on a workplane perpendicular to the recessed surface, extrude that polygon as difference.
But there are no grooves, only sawtooth holes on side.
Is there a mode to create that grooves?
See attached test project.
I am want to create a grooved recessed surface.
So I draw a sawtooth polygon on a workplane perpendicular to the recessed surface, extrude that polygon as difference.
But there are no grooves, only sawtooth holes on side.
Is there a mode to create that grooves?
See attached test project.
(no subject) (by Daniel Engineering Solutions)
Gian,
It looks like you drew the saw teeth too deep on the part and that they are cut from underneath where you'd want. I'm not sure exactly how you want this to look, but attached is my best attempt at making what I think you're going for.
It looks like you drew the saw teeth too deep on the part and that they are cut from underneath where you'd want. I'm not sure exactly how you want this to look, but attached is my best attempt at making what I think you're going for.
Re: Create grooves in recessed surface (by Gian)
Daniel,
thank you very much, closing the sawtooth figure on top and not on bottom is the trick that works.
More, I was wrong putting the sawtooth on external side of solid. This creates the holes on side.
I have to put the sawtooth on recess face.
Attached the final project.
thank you very much, closing the sawtooth figure on top and not on bottom is the trick that works.
More, I was wrong putting the sawtooth on external side of solid. This creates the holes on side.
I have to put the sawtooth on recess face.
Attached the final project.
Post a reply to this comment: