USER FORUM
(you are viewing a thread; or go back to list of threads)
Bent tube. (by Maxmans)
Hello, a question: If I want to draw a piece like the one in the photo, should I assemble it or can I do it in a single working plane? Thank you.
(no subject) (by Tom)
I don't know any way except piecewise, as two cylinders plus a lathe for the join.
(no subject) (by Maxmans)
Thank you, Tom.
(no subject) (by Daniel Engineering Solutions)
Maxmans,
They are currently working on a "sweep along path" tool which would enable you do to what you're thinking in 2 sketches and a single sweep. That tool hasn't been released yet so as of right now you'll have to do it piecewise as Tom mentioned.
They are currently working on a "sweep along path" tool which would enable you do to what you're thinking in 2 sketches and a single sweep. That tool hasn't been released yet so as of right now you'll have to do it piecewise as Tom mentioned.
(no subject) (by Maxmans)
Thank you, Daniel.
(no subject) (by Ali)
Good evening, Maxmans,
Here is a youtube video of someone doing what, I think, is similar to what you are asking. He makes 90° bends though I think you can change the angle for your needs. Hope it helps.
https://www.youtube.com/watch?v=blkjW0JauX8
Sincerely,
Ali
Here is a youtube video of someone doing what, I think, is similar to what you are asking. He makes 90° bends though I think you can change the angle for your needs. Hope it helps.
https://www.youtube.com/watch?v=blkjW0JauX8
Sincerely,
Ali
(no subject) (by Maxmans)
That's the solution I was looking for, Ali, thank you very much.
Post a reply to this comment: