USER FORUM
(you are viewing a thread; or go back to list of threads)
make end of cylinder new workplane (by Peter Bunge)
I extruded to a cylinder. Now I want to build on the end.
How can I "Sketch in new workplane"?
Selecting the top surface does not work.
Selecting the center and perimeters does not work.
How can I "Sketch in new workplane"?
Selecting the top surface does not work.
Selecting the center and perimeters does not work.
(no subject) (by Marcel d)
hey,
just select the center of the cylinder, nothing else that should work
see attached file
just select the center of the cylinder, nothing else that should work
see attached file
(no subject) (by Peter Bunge)
Yes that works. Thanks.
I kept reading the errors and was over thinking it.
I kept reading the errors and was over thinking it.
Post a reply to this comment: