USER FORUM
(you are viewing a thread; or go back to list of threads)
DXF Export (by Paul)
I use Solvespace V3 on both a mac and Windows machine.
When I export the file to DXF for use in "Sheetcam", I first check it in "eMachineshop" so that I can view the 2d drawing in a 3d view (showing bend lines/folds).
All designs are eventually cut on a plasma table.
eMachineshop never imports the DXF correctly, only a few of the lines are visible.
If i pull the drawing into Qcad, then save it again, then the DXF is opened correctly.
I'm guessing this is an issue with the verion of DXF saved by Solvespace, is there any way to change the version of the DXF saved, or does anyone have any tips to save the DXF differently ?.
When I export the file to DXF for use in "Sheetcam", I first check it in "eMachineshop" so that I can view the 2d drawing in a 3d view (showing bend lines/folds).
All designs are eventually cut on a plasma table.
eMachineshop never imports the DXF correctly, only a few of the lines are visible.
If i pull the drawing into Qcad, then save it again, then the DXF is opened correctly.
I'm guessing this is an issue with the verion of DXF saved by Solvespace, is there any way to change the version of the DXF saved, or does anyone have any tips to save the DXF differently ?.
Post a reply to this comment: