USER FORUM
(you are viewing a thread; or go back to list of threads)
question from tutorial 1 (by ajoeiam)
Greetings
Working through tutorial 1.
Made an error so that the gusset sketch is placed at one end rather than where its called for - - the middle.
If I wanted to have three gussets - - - - one inset slightly from each end and the middle, is there a way to draw one and create the other two as linked yet independently place.
(Linked as to size and handling even given the different locations. I have used such in weldments in the past.
Working through tutorial 1.
Made an error so that the gusset sketch is placed at one end rather than where its called for - - the middle.
If I wanted to have three gussets - - - - one inset slightly from each end and the middle, is there a way to draw one and create the other two as linked yet independently place.
(Linked as to size and handling even given the different locations. I have used such in weldments in the past.
(no subject) (by Andrew)
For evenly spaced repeats, use the step translating, or step rotating in new group. Alternatively, and for uneven spacing, create the component is a separate file, and link assemble as and where needed. This latter approach allows for uneven spacing and rotating individual additions to the model.
Post a reply to this comment: