USER FORUM
(you are viewing a thread; or go back to list of threads)
Cone with the base in a circle and the top in an ellipse. (by Razvan)
Hello,
I'm trying to make a cone that starts with a circle base and ends up with an ellipse top.
Is this possible?
Thanks,
Razvan
I'm trying to make a cone that starts with a circle base and ends up with an ellipse top.
Is this possible?
Thanks,
Razvan
(no subject) (by Eric Buijs)
Do you want the cone and the ellipse to be parallel? If not just do a diagonal section cut with a cone and a large cube.
Post a reply to this comment: