USER FORUM
(you are viewing a thread; or go back to list of threads)
Angle Set to 180 Causes Subsequent Failures (by Tom Sato)
Hi Jonathan,
I've noticed that if the angle between two line segments is set to 180 degrees, all subsequent attempts to change the angle returns a failure. Is this a known behavior? Is there anything I can do to prevent this from happening?
Many thanks,
Tom
I've noticed that if the angle between two line segments is set to 180 degrees, all subsequent attempts to change the angle returns a failure. Is this a known behavior? Is there anything I can do to prevent this from happening?
Many thanks,
Tom
(no subject) (by Jonathan Westhues)
Solutions for small angles are improved by
https://github.com/jwesthues/s...03fb4f7fb712d8bc0bb63ba6087f83 ,
which isn't yet in a release. But why not just constrain parallel?
https://github.com/jwesthues/s...03fb4f7fb712d8bc0bb63ba6087f83 ,
which isn't yet in a release. But why not just constrain parallel?
(no subject) (by Tom Sato)
Thanks Jonathan. Looking forward to the release. A parallel constraint can certainly be used, but I was experimenting with different behaviors and use cases.
Post a reply to this comment: