USER FORUM
(you are viewing a thread; or go back to list of threads)
Mystery red lines, circles (by Walter Cadek)
Today I worked on a simple model, which I have to build in different versions. Mirroring a.s.o was helpful, but did not work as expected, just a part was mirrored, the rest was still the same.
Now I have a model, which is very simple, but delivers red circles.
1. plane is ok,
2. extruding is ok
3. scetch on the extruded body is ok
4. extruding works ok, but produces a red circle in the first plane !!!
Question: Why produces an extruding of the 2. plane an error in the first plane?
I will design the part as new and hope this will result in a perfect design.
The enclosed file might help you to investigate the misbehavior.
Best regards
Walter
Now I have a model, which is very simple, but delivers red circles.
1. plane is ok,
2. extruding is ok
3. scetch on the extruded body is ok
4. extruding works ok, but produces a red circle in the first plane !!!
Question: Why produces an extruding of the 2. plane an error in the first plane?
I will design the part as new and hope this will result in a perfect design.
The enclosed file might help you to investigate the misbehavior.
Best regards
Walter
(no subject) (by Andrew)
The problem you have tried to continue and extruded hole into a separate block, and tripped a bug by having co-incident ends to two extrusions. You can fix the problem by making the extrude as a separate operation. Fixed model attached.
Post a reply to this comment: