USER FORUM
(you are viewing a thread; or go back to list of threads)
dof error with single lines (by Markus)
Hi,
in several cases I need a single line for engraving or milling a groove and not a closed segment like rectangle or circle. In this cases the dof-check jumps to err and I can not see or check other dependencies/constraints anymore.
Is there a possibility to exclude these lines (or some other segments) from constraint checking?
Or any other solution?
Thank you
Markus
in several cases I need a single line for engraving or milling a groove and not a closed segment like rectangle or circle. In this cases the dof-check jumps to err and I can not see or check other dependencies/constraints anymore.
Is there a possibility to exclude these lines (or some other segments) from constraint checking?
Or any other solution?
Thank you
Markus
(no subject) (by Tom)
I think that's just a display bug? You can turn off "check closed contour" in the config screen and the warning disappears from the sketch, but the group list display still says "err". The constraints still work normally and the exported file looks right, so you can probably just ignore the "err".
(no subject) (by Paul)
I verified in the latest edge build (by testing it and reading the code) that unchecking the box "check sketch for closed contour" will eliminate "err" and show the DoF.
Post a reply to this comment: