USER FORUM
(you are viewing a thread; or go back to list of threads)
redundant constrain (by ibo de groot)
Hello,
I wouldt like to constrain the smaller part of the cilinder but when i try to constrain this part i will get a redundant constrain. if i allow the constrain i am not able to get this part to the desired dimensions. what am i doing wrong?
Ibo
I wouldt like to constrain the smaller part of the cilinder but when i try to constrain this part i will get a redundant constrain. if i allow the constrain i am not able to get this part to the desired dimensions. what am i doing wrong?
Ibo
(no subject) (by Andrew)
You can only constrain the diameter in the sketch, before you extrude it. After extrusion you can constrain the length.
Post a reply to this comment: