USER FORUM
(you are viewing a thread; or go back to list of threads)
Assembly moving constrains (by tpimh)
Is there a way to limit the movement of the point #3 on the picture just between points #1 and #2? If yes, what should I do to achieve this?
(no subject) (by whitequark)
Inequality constraints are not supported.
One Solution (by NIPA)
In a part this is how you can do it.
Connect a line between two points #1 and #2.
Draw a cricle between the end points #1 and #2 as Diameter. Create a line on the plane of the circle,
- perpendicaular to the first line
- with one end constrained on the circle
- second end on the first line <- This is your Point #3
#3 is now Constrained between #1 and #2
Use this point to assembly your Second Part
See attached file.
Connect a line between two points #1 and #2.
Draw a cricle between the end points #1 and #2 as Diameter. Create a line on the plane of the circle,
- perpendicaular to the first line
- with one end constrained on the circle
- second end on the first line <- This is your Point #3
#3 is now Constrained between #1 and #2
Use this point to assembly your Second Part
See attached file.
(no subject) (by tpimh)
Thank you, NIPA! Very interesting solution.
Post a reply to this comment: