USER FORUM
(you are viewing a thread; or go back to list of threads)
Fitting a cylinder into a pipe (by Andreas)
Is it possible to fit a cylinder with outder diameter OD into a pipe with an inner diameter ID=OD without constraint errors or is that per definition not possible (sharing the same face?)?
All is fine until I bring the two to the same height (Cap-4.png)
All is fine until I bring the two to the same height (Cap-4.png)
(no subject) (by Eric Buijs)
You could increase the height of the inner cylinder to 10.01.
(no subject) (by Andreas)
Eric, thanks yeah that's a workaround that might work sometimes but then the dimension will be statically defined and won't be following the length of the pipe if that dimension is changed.
Issue or by design?
Issue or by design?
Post a reply to this comment: