USER FORUM
(you are viewing a thread; or go back to list of threads)
extrude selected closed loop. (by wolfv)
I did four of the tutorials and referred to the reference manual.
The SolveSpace interface is clean, very nice.
I learned a lot without having to ask questions.
But I have to ask now.
A sketch has two closed loops.
Is there a way to extrude just one of the closed loops?
Thank you.
The SolveSpace interface is clean, very nice.
I learned a lot without having to ask questions.
But I have to ask now.
A sketch has two closed loops.
Is there a way to extrude just one of the closed loops?
Thank you.
(no subject) (by wolfv)
I not longer need to extrude just a selected loop. I found a better way.
Maybe modeling the SolveSpace way only requires extruding the entire sketch?
Maybe modeling the SolveSpace way only requires extruding the entire sketch?
(no subject) (by Jonathan Westhues)
Mark the entities that you don't want to extrude as construction (Sketch -> Toggle Construction).
Solved (by wolfv)
Thanks Jonathan.
Post a reply to this comment: